ComandPlus Console Upgrade?

jayres · Post by **jayres** » Wed Feb 18, 2004 12:02 am

Anybody have any knowledge of an upgrade for the CommandPlus Console? Supposedly it will give you 2-tone paging as well as several other features... When I called gai-tronics, they said it's appx $200

, but didnt say if it was hardware or software related. Our current CommandPlus doesn't have 2-tone and that's the only thing we need...

Anybody have any previous experience or insight here?

Thanks!

The Pager Geek · Post by **The Pager Geek** » Wed Feb 18, 2004 4:55 am

Check the main page of batlabs under model specific.. there should be an upgrade there, unless they closed that loophole.

tpg

jayres · Post by **jayres** » Wed Feb 18, 2004 3:49 pm

I'm assuming you mean under the Comtegra information for the upgrade, have tried that numerous times with no results...

any other ideas / info out there?

Alan · Post by **Alan** » Thu Feb 26, 2004 9:37 pm

Just installed the upgrade in a console.
It is an activation code. Done over the phone when you are in front of the console.
Programming required to configure the signaling systems afterwards.

jayres · Post by **jayres** » Sun Feb 29, 2004 1:32 pm

Alan, is the activation code specific to console (by serial number or other)? Or is it just a general activation?

Thanks!

Alan · Post by **Alan** » Sun Feb 29, 2004 2:36 pm

Specific to the console.
To activate, you phone Gai-tronics tech support when you are in front of the console.
They will ask you for some info from one of the set-up screens, they give you a series of numbers to input, the console will generate some numbers, you give them those numbers and they give you a final set of numbers to input.
Reset the console, and the option is activated.