APX 7000 channel selector knob swap-out
Moderator: Queue Moderator
APX 7000 channel selector knob swap-out
OK, so I picked up one of the "fat" APX 7000 knobs, but I'm reluctant to destroy the "tiny" one off my radio without knowing if this new "fat" OEM knob is just a direct swap. If the tiny knob is removed, the fat one looks like it might not go all the way "down" the stem. Is there something I'm missing? Anyone swapped one of these out before?
Re: APX 7000 channel selector knob swap-out
Pull the tiny one off, and push the fat one on.. Easy as that.
-Marc
-Marc
Stupidity creates job security!
If your radio has old firmware, programming it with the latest CPS will not add any new features unless you have the latest firmware to match..
CPS = Customer Programming Software, Not CPS Software.
If your radio has old firmware, programming it with the latest CPS will not add any new features unless you have the latest firmware to match..
CPS = Customer Programming Software, Not CPS Software.
Re: APX 7000 channel selector knob swap-out
Dang...that *was* easy! I just did it in 10 seconds. Thanks for the confirmation. I just wasn't sure if the new one slid all the way down or not. Didn't even need any pliers (can't recall who said pliers, but they are not needed).Mfire39 wrote:Pull the tiny one off, and push the fat one on.. Easy as that.
-Marc
Thanks!
Re: APX 7000 channel selector knob swap-out
Anyone know the part# for the fat knob?
-
- Posts: 110
- Joined: Fri Nov 25, 2005 7:29 pm
- What radios do you own?: APX7500 plus too many to list
Re: APX 7000 channel selector knob swap-out
Part number 3675590B02