Okay, so I got an R1225 repeater with of course a bad PA. Reading around here on batlabs, I see some people have gone to instead replace the bad PA with a GM300 PA. Since I have a few UHF GM300s laying around, I figure I would do the upgrade.
Is pretty much putting in a GM300 PA in a R1225 just like putting in a normal R1225 PA in these things? Anything to look out for or special?
R1225 PA upgrade to GM300
Moderator: Queue Moderator
R1225 PA upgrade to GM300
Mountain Wave Search & Rescue http://www.mwave.org
Support Search & Rescue: Get Lost!
Support Search & Rescue: Get Lost!
Re: R1225 PA upgrade to GM300
Yes a FULL alignment of the TX PA section in the RSS/CPS.
The filtering in the R1225 PA is much better and no ant switch diodes to get upset in a high RF environment.
I will take the old R1225 PA.
The filtering in the R1225 PA is much better and no ant switch diodes to get upset in a high RF environment.
I will take the old R1225 PA.
Re: R1225 PA upgrade to GM300
Good to know!
And sorry, the PA is spoken for already by a friend.
And sorry, the PA is spoken for already by a friend.
Mountain Wave Search & Rescue http://www.mwave.org
Support Search & Rescue: Get Lost!
Support Search & Rescue: Get Lost!
Re: R1225 PA upgrade to GM300
Will - Do you want old GR1225 RFPA sections?
Re: R1225 PA upgrade to GM300
Bill_G wrote:Will - Do you want old GR1225 RFPA sections?
Yes, I rebuild them in my spare time for replacement on some GM300 radios used as transmitters in repeaters.