CDM750 TX Alignment?
Moderator: Queue Moderator
CDM750 TX Alignment?
I'm using the PRO CPS software R6.12.05. There is supposed to be a separate ' TX Align ' section I cannot find. Is this separate software? I need to raise the deviation. It seems to be hard limited to 3KC, even though I have the personalitiy set for 25KC spacing.
Re: CDM750 TX Alignment?
Yes, there's a separate program called TUNER that does all the alignments.
If the programming software is newer than a few years, remember that it only allows narrow-band (2.5 kHz) programming unless you've got the special entitlement key to allow 5 kHz deviation.
Bob M.
If the programming software is newer than a few years, remember that it only allows narrow-band (2.5 kHz) programming unless you've got the special entitlement key to allow 5 kHz deviation.
Bob M.
- jackhackett
- Posts: 1515
- Joined: Tue Jun 10, 2003 8:52 am
Re: CDM750 TX Alignment?
As I recall R6.12.05 was the last version before you needed the entitlement key.
- SteveC0625
- Posts: 467
- Joined: Sat Jan 01, 2011 9:46 am
- What radios do you own?: CDM's, CP's, CM's, and more
Re: CDM750 TX Alignment?
On the disc you received from Motorola or in the computer file you downloaded from MOL, there should be a separate Zip file called Global Tuner. There's no install procedure for it, just unpack it into a sub-directory on your CP and run it.leaper54 wrote:I'm using the PRO CPS software R6.12.05. There is supposed to be a separate ' TX Align ' section I cannot find. Is this separate software? I need to raise the deviation. It seems to be hard limited to 3KC, even though I have the personalitiy set for 25KC spacing.
It's also still available at MOL --> Resource Center --> Software --> HT-EX and CDM. The most current version appears to be 2.18.0.