Looking for Permanent Mount Cell Phone Pwr supply

This forum is dedicated to helping people with questions about installing radio equipment in vehicles. This can include antenna installs, electrical wiring questions/problems, and mounting systems. Pictures of installs are welcome.

Note: Discussions regarding lighting, sirens, and other equipment now has its own forum in the 'off-topic' section below.

Moderator: Queue Moderator

Post Reply
WCHija
Posts: 552
Joined: Thu Jun 28, 2007 6:49 pm
What radios do you own?: XTL & XTS

Looking for Permanent Mount Cell Phone Pwr supply

Post by WCHija »

I need to mount a permanent 5V power supply for cell phone charging. The phone will normally sit in a cradle, and having a traditional cig lighter adapter is not working due to the extra clutter it causes and the limited number of out lets available.

I need to find a solution I can mount in the console or dash to power the phone, anyone have any suggestions?
Semper Fidelis
mmckenna
Posts: 217
Joined: Wed Aug 28, 2002 7:01 pm
What radios do you own?: AM/FM with 8 track.

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by mmckenna »

I built a little box with a 7805 regulator in it to produce 5 volts for a GPS receiver. It was pretty easy to make, you should be able to find a lot of info on the net. Probably cost me less than $10 including a little box to mount it in. It's pretty small and I just stuck it up under the dash board.
"The nice thing about standards is that there are so many to choose from."
User avatar
SteveC0625
Posts: 467
Joined: Sat Jan 01, 2011 9:46 am
What radios do you own?: CDM's, CP's, CM's, and more

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by SteveC0625 »

Another alternative is to get one of these guys:

http://www.ebay.com/itm/Auto-Car-Black- ... 0860749977

Hardwire it to your fuse block or where ever, plug in your cell phone charger, tape it up so it doesn't work loose, and tuck it up under the dash with some tie-wraps. When we traded in our old Jeep, I found the aftermarket satellite receiver was installed that way several years ago by an install shop (wife insisted on paying the buck for "pro" install.) I kept it that way when I moved it into my truck, and for much the same reason as you.
WCHija
Posts: 552
Joined: Thu Jun 28, 2007 6:49 pm
What radios do you own?: XTL & XTS

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by WCHija »

Thanks for the suggestions, I was hoping to find something a little more custom. I guess Ill keep looking.
Semper Fidelis
User avatar
maxkelley_kc2spy
Posts: 160
Joined: Fri May 01, 2009 2:30 am
What radios do you own?: XTS2.5K-Q, ASpectra, MT2K

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by maxkelley_kc2spy »

An ebay search for "dc-dc converter 5v" turned up some interesting results that might just work for you. Some of them supply USB jacks, which could work great for a phone with a USB charging cord.

http://www.ebay.com/itm/DC-DC-Converter ... 067wt_1396

or with USB

http://www.ebay.com/itm/DC-DC-Converter ... 653wt_1243

Cheap-cheap, too!
Max Kelley KC2SPY
http://www.maxkelley.com
MT2000 VHF & UHF A7, Visar UHF, ASII UHF, Maratrac UHF, Astro Spectra UHF, MCS2KIII 900, XTS2.5K-Q
WCHija
Posts: 552
Joined: Thu Jun 28, 2007 6:49 pm
What radios do you own?: XTL & XTS

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by WCHija »

The second one looks perfect, isnt 3A too high though?
Semper Fidelis
User avatar
Tom in D.C.
Posts: 3859
Joined: Tue Sep 04, 2001 4:00 pm
What radios do you own?: Progreso soup can with CRT

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by Tom in D.C. »

The charger will provide UP TO 3 Amperes when in operation, that's the way current works.
Tom in D.C.
In 1920, the U.S. Post Office Department ruled
that children may not be sent by parcel post.
WCHija
Posts: 552
Joined: Thu Jun 28, 2007 6:49 pm
What radios do you own?: XTL & XTS

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by WCHija »

Thanks, I forgot about that. Looks like a perfect solution.
Semper Fidelis
User avatar
Wowbagger
Aeroflex
Posts: 1287
Joined: Tue Dec 10, 2002 10:46 am

Just switch it.

Post by Wowbagger »

Just make sure it is on switched (accessory) power, not always hot (battery) - it WILL draw some current even when not charging your phone, and if you don't switch it, it WILL run your battery down at the most inconvenient time.
This is my opinion, not Aeroflex's.

I WILL NOT give you proprietary information. I make too much money to jeopardize my job.

I AM NOT the Service department: You want official info, manuals, service info, parts, calibration, etc., contact Aeroflex directly, please.
WCHija
Posts: 552
Joined: Thu Jun 28, 2007 6:49 pm
What radios do you own?: XTL & XTS

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by WCHija »

Thanks
Semper Fidelis
Skooter92
Posts: 65
Joined: Tue Jan 10, 2006 7:31 pm

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by Skooter92 »

Are you looking for a mini-USB terminated direct wire power cord? I only ask because most cellphones are going to them for power/data, and the 5 volt requirement. If so, check this out-http://www.gpsgeek.com/products/gusb5v- ... -1412-1430
*************************
Fairly well grounded......
User avatar
Wowbagger
Aeroflex
Posts: 1287
Joined: Tue Dec 10, 2002 10:46 am

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by Wowbagger »

Skooter92 wrote:Are you looking for a mini-USB terminated direct wire power cord? I only ask because most cellphones are going to them for power/data[/url]
Most phones are going to MICRO-USB, not mini-USB. Indeed, the USB consortium has deprecated the mini-USB format as it is not as mechanically robust as the micro-USB connector.
This is my opinion, not Aeroflex's.

I WILL NOT give you proprietary information. I make too much money to jeopardize my job.

I AM NOT the Service department: You want official info, manuals, service info, parts, calibration, etc., contact Aeroflex directly, please.
mike38015
Batboard $upporter
Posts: 167
Joined: Wed Sep 05, 2001 4:00 pm

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by mike38015 »

JAS93550
New User
Posts: 1
Joined: Thu Apr 12, 2012 3:34 pm

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by JAS93550 »

I agree with Wowbagger, you need to connect to accessory power.
I recommend the units by 12 Volt Designs, they come with an iPod/iPhone cable and you can use your own USB Type A to USB Mini or Micro cables so you are not limited to the cabling for your usage. Plus these things are solid as a brick.
I saw them on Amazon and eBay and ended up buying direct from the manufacturer.
The Amazon listing for their “Dual Port” charger lists the standby current at 10A, but the ebay listing and their website lists it at 10mA so I think this is just a typo on the Amazon listing.
WB4JGI
was whitstu
Posts: 472
Joined: Sat Jan 07, 2006 11:11 am

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by WB4JGI »

I use this one in my Tahoe to charge my Droid and it works great.

http://order.waytekwire.com/productdeta ... 20CHARGER/

And a quick search for angled USB cables came up with this site:

http://www.angledcables.com/a-to-micro-b.html

I may need to revisit my install and use angled connectors instead.
Stu
User avatar
tdats
Posts: 172
Joined: Tue Jun 10, 2008 8:23 am
What radios do you own?: Mostly Motorola

Re: Looking for Permanent Mount Cell Phone Pwr supply

Post by tdats »

In my tahoe, I took one of the lighter plug cables, popped it apart and mounted it inside the console powered off one of the switched circuits. Had to extend some of the wires in it, and add a different fuse holder. Was able to run the wire out of a existing hole. Me and my wife have the same phone, so being able to swap chargers is not an issue for us. Keeps the plug open for other things that way.
Post Reply

Return to “Vehicle Radio Installs”