GM300 P5 on screen - Error Code 2056
Posted: Sat Sep 29, 2018 1:55 pm
Hello,
I have a GM300 MODEL : M43GMC29C2AA, have made a programing cable as per https://www.george-smart.co.uk/scrapbook/gm300_cables/ , When I switch it on there is a along tone beep and a P5 is displayed on the screen. using dosbox on win8.1 I can run the dos based programming software. The com test is successful. When I Read the radio, it reads the code plug from 1-20 and then states "A run time error has occurred Signed value out of range Error Code 2056" in a red popup. I have searched the internet but I cannot find any information on this. Any help/guidance/support would be much appreciated.
73's
AP2CJ
I have a GM300 MODEL : M43GMC29C2AA, have made a programing cable as per https://www.george-smart.co.uk/scrapbook/gm300_cables/ , When I switch it on there is a along tone beep and a P5 is displayed on the screen. using dosbox on win8.1 I can run the dos based programming software. The com test is successful. When I Read the radio, it reads the code plug from 1-20 and then states "A run time error has occurred Signed value out of range Error Code 2056" in a red popup. I have searched the internet but I cannot find any information on this. Any help/guidance/support would be much appreciated.
73's
AP2CJ