Mototrbo CPS question: Version
Posted: Wed Aug 28, 2019 12:42 am
Hi,
I just got my hands on a Motorola XiR P8600 (For other regions: DP4400, XPR7350, DGP5050).
It is a second hand unit and I have not get a programming cable for myself yet. FW02.06.11 on the sticker.
However, I have the CPS v10 AZ software which I had installed earlier.
What I am worried about is, does anyone have any advice on should I use the version 10 of CPS or should I find a lower version?
I heard that there are problems with locking it into narrowband mode if you use anything later than CPS v8.0
Should I be concerned about this?
I just find that it is very hard to find information on the Mototrbo but this site looks like it has a lot of discussions going on.
I am planning to borrow a programming cable from a friend to enable the Bluetooth toggle button and install a Bluetooth board instead later on for CPS programming. Just wondering if I will miss anything when using the BT board.
Cheers
I just got my hands on a Motorola XiR P8600 (For other regions: DP4400, XPR7350, DGP5050).
It is a second hand unit and I have not get a programming cable for myself yet. FW02.06.11 on the sticker.
However, I have the CPS v10 AZ software which I had installed earlier.
What I am worried about is, does anyone have any advice on should I use the version 10 of CPS or should I find a lower version?
I heard that there are problems with locking it into narrowband mode if you use anything later than CPS v8.0
Should I be concerned about this?
I just find that it is very hard to find information on the Mototrbo but this site looks like it has a lot of discussions going on.
I am planning to borrow a programming cable from a friend to enable the Bluetooth toggle button and install a Bluetooth board instead later on for CPS programming. Just wondering if I will miss anything when using the BT board.
Cheers