Whelen Edge Power Supply vs. flash pattern question
Posted: Wed May 24, 2006 7:47 pm
Hey everyone.
If any of you can help me it would be greatly appreciated. I am working on an 8 strobe, 4 flasher, 2 alley light edge 9000 lightbar with a friend and we are trying to get the flash pattern so it goes from comet flash, to single strobe bursts, to comet flash, to single strobe bursts and so on. We are also trying to make it so that the takedowns flash, as do the rear flashers. Available to us are Whelen SL6 and EB6 Power supplies and we are not sure which one to use. We only have one EB6 and four SL6.
I have printed out Whelen's diagram on changing the flash pattern, but it did not help. The flash pattern is supposed to change(according to the diagram) with the brown wire in the strobe cable, but that does nothing.
I would also like to know how to make it so that the takedowns and rear flashers alternate. Along with the two power supplies is a circut board where most of the wires lead to.
If anyone can help, it would be greatly appreciated!
Thanks!
If any of you can help me it would be greatly appreciated. I am working on an 8 strobe, 4 flasher, 2 alley light edge 9000 lightbar with a friend and we are trying to get the flash pattern so it goes from comet flash, to single strobe bursts, to comet flash, to single strobe bursts and so on. We are also trying to make it so that the takedowns flash, as do the rear flashers. Available to us are Whelen SL6 and EB6 Power supplies and we are not sure which one to use. We only have one EB6 and four SL6.
I have printed out Whelen's diagram on changing the flash pattern, but it did not help. The flash pattern is supposed to change(according to the diagram) with the brown wire in the strobe cable, but that does nothing.
I would also like to know how to make it so that the takedowns and rear flashers alternate. Along with the two power supplies is a circut board where most of the wires lead to.
If anyone can help, it would be greatly appreciated!
Thanks!