Hi All,
I'm planning to program a GM360 radio but while making the cable for it a came across pin 25 which isn't connected in my RIB
cable pinout : http://www.batlabs.com/images/cdmprog.gif
Rib schematic : http://www.batlabs.com/images/rib.gif
So how/where do I connect the pin 25 to ??
All help is greatly appreciated
Thanks,
Jimmy
pin 25 in RIB missing ??
Moderator: Queue Moderator
- HLA
- Posts: 2334
- Joined: Mon Jul 11, 2005 8:15 pm
- What radios do you own?: HT1550's, X9000's, CDM1550's
don't worry about what's going on in the rib box. pin 25 is used to boot the radio. you can actually skip that wire if you don't plan on flashing the radio. what happens when you get ready to flash the radio you flip a switch on another adaptor (that you don't have) that connects i think pin 1 & 25 and that boots the radio. so for normal programing you don't need it and that's why it isn't in the rib. it gets used by the radio, not the rib.
HLA
I never check PM's so don't bother, just email me.
I won't reply to a hotmail, gmail, aol or any other generic free address, if you want me to reply use a real address.
STOP ASKING ME FOR SOFTWARE OR FIRMWARE, I JUST FORWARD ALL OF THE REQUESTS TO THE MODERATORS
I never check PM's so don't bother, just email me.
I won't reply to a hotmail, gmail, aol or any other generic free address, if you want me to reply use a real address.
STOP ASKING ME FOR SOFTWARE OR FIRMWARE, I JUST FORWARD ALL OF THE REQUESTS TO THE MODERATORS