Minitor 5 Group Call
Moderator: Queue Moderator
-
- New User
- Posts: 1
- Joined: Tue Jan 13, 2009 10:23 am
Minitor 5 Group Call
I am trying to program my pager to go off for Group Call, Long tone B. But right now it is going off for everything. I am using R138, Tone A and Tone B is duty and then long tone B is all call when off duty. Any ideas ?
Re: Minitor 5 Group Call
Go to the FUNCTION SWITCHES Tab and place a check in the ENABLE ON/OFF DUTY BOX for the Mode Switch position or positions where you want your pager to respond to the Long Tone B only.
Now go to the CHANNEL F1 Tab and to the right of the Tone1 & Tone 2, set the Duty to OFF.
Make sure that the Duty is set to ON for Group Call 1 (your Long Tone B).
Now when you go to the Mode Switch position(s) where the ON/OFF Duty function is enabled (Box checked)... the decoder will see that the Tone 1/Tone 2 set is turned OFF and the pager will activate only with the Long Tone B.
When you are on a Mode Switch position where the ON/OFF Duty Box is not checked, the decoder will activate for all tone sequences in the list.
Hope this helps!
Bob, CLARKCOMM
Now go to the CHANNEL F1 Tab and to the right of the Tone1 & Tone 2, set the Duty to OFF.
Make sure that the Duty is set to ON for Group Call 1 (your Long Tone B).
Now when you go to the Mode Switch position(s) where the ON/OFF Duty function is enabled (Box checked)... the decoder will see that the Tone 1/Tone 2 set is turned OFF and the pager will activate only with the Long Tone B.
When you are on a Mode Switch position where the ON/OFF Duty Box is not checked, the decoder will activate for all tone sequences in the list.
Hope this helps!
Bob, CLARKCOMM