I am trying to set up a Minitor II for Set 8 (A-b, C-B) however there is no 3c3 jumper on the board. I am assuming that my board is a different revision than the one on the batlabs site. Any info would be helpful. Thanks!!!
Craig
Minitor II Set 8
Moderator: Queue Moderator
Re: Minitor II Set 8
Craig,
Jumper 3C3 applied to early Minitor II Decoder Boards, like model NRN5493A.
Your decoder board should be labeled NRN6190A
If so, Jumper Set 8 (option R177) A-B, C-B is as follows:
3C1 OUT
3C2 OUT
3C4 IN
3C5 OUT
3C8 OUT (requires cutting the circuit)
3C9 IN
3C10 IN
3C11 OUT (requires cutting the circuit)
Hope this helps.
Bob, CLARKCOMM
Jumper 3C3 applied to early Minitor II Decoder Boards, like model NRN5493A.
Your decoder board should be labeled NRN6190A
If so, Jumper Set 8 (option R177) A-B, C-B is as follows:
3C1 OUT
3C2 OUT
3C4 IN
3C5 OUT
3C8 OUT (requires cutting the circuit)
3C9 IN
3C10 IN
3C11 OUT (requires cutting the circuit)
Hope this helps.
Bob, CLARKCOMM
Re: Minitor II Set 8
Great, thanks!!
Craig
Craig