You will need to have an interface from the Cisco phone that provides 1. Rx audio pair, 2. Tx audio pair. 3. Off-Hook Pair. SOME phone manufacturers do provide an add-on module to the phone set for this purpose. Don't know about Cisco but if you have a support number for them best thing to do is cal...

Yes- but that's just the hardware end of it. There's also a different flex kit on the back end and you may need to upgrade the Flashcode as well to make it do what you want.

I haven't had an XTL in my truck for awhile now but I do have an APX8500 now and just prior to that a Dual Radio setup with two APX7500s and 07 head. I can say without a doubt the weak signal sensitivity in analog (e.g.146.520) is at least as good as the published spec of -121dBm (-123 with preamp) ...

There is a guy on E Bay who makes custom extender boards. I caught his ad while poking around for R2001D. He had a full set for that one and claimed he could make just about anything.

Call Freedom. They still support the 2600 line. http://freedomcte.com/wp-content/upload ... cement.pdf

Hello on the list,

I recently came into a couple of well used Motorola R2014D Communications Analyzers.They're a little rough but working. Does anyone have access to a Service Manual for this model that they would be willing to share or part with? Thanks.

Yes- I'm familiar with it. What's your question?

What baud rate are you attempting to use? The MUPL defaults to 300 which for a new programming job I would recommend. If you try and force it to 9600 it can be persnicitty. Also check the last dip switch (bottom if the board is upright in the cage) and make sure it is toward the back of the board fo...

Had this happen to more than one customer of mine as well- very frustrating. I kept my eye on Ebay and Panik Electronics for months with no joy. Seems once they have it it's GONE.JJ

Check JU1 and JU2 on your BIMS. If they are in the 2D and 4D positions respectively, this sets the normal (Domestic) receive threshold of -25 Dbm. Any incoming audio below that nominal level will be muted to the operator, although not necessarily to the logging output of the BIM. These "audio h...