I cant get my ss2000 into programming mode
i have tried keying the mike while holding down the save button and turning the unit on
is there something else im missing
i have did this before with my other units with no problem, this one seems to be a pain
ss2000sm help
Moderator: Queue Moderator
Re: ss2000sm help
thanks, i appreciate that
i was already there and that didnt help so i went and tried a different control head
and that fixed the issue
the control head i am using wont allow you to program it however you can program
it with the other head and use the new head to run it
thanks again
ryan
i was already there and that didnt help so i went and tried a different control head
and that fixed the issue
the control head i am using wont allow you to program it however you can program
it with the other head and use the new head to run it
thanks again
ryan
Re: ss2000sm help
Glad you got your head(s) on straight
Re: ss2000sm help
If you read the Fed Sig configuration manual, there is a jumper inside the control head that disables user programming... Solder it back together and you'll be good to godewy wrote:thanks, i appreciate that
i was already there and that didnt help so i went and tried a different control head
and that fixed the issue
the control head i am using wont allow you to program it however you can program
it with the other head and use the new head to run it
thanks again
ryan