Hello All!
I am in need of some HT-1000 repairs
I have two UHF HT-1000's that I bought at auction.
One has transmit problems. The red transmit lights up, but there is no transmit being show on the frequency counter.
The other does not transmit at all.
They both power up and go through the self-check fine, they just will not transmit.
All 16 Channels are programmed with both transmit and receive frequencies and Pl's.
Please PM me with ideas or if you are able to assist me.
Any help would greatly be appreciated
Thanks
David
HT-1000 Help
Moderator: Queue Moderator
-
yardbirdjr
- Posts: 424
- Joined: Thu Feb 13, 2003 10:04 am
Re: HT-1000 Help
I had a few like the first one....
Strip it and check that the springy-thingy [RF output tab from board to antenna connector] on the board is touching the antenna plate, and not grounding against the radio chassis. It gets bent in the reassembly sometimes.
worst case is fried finals...
Second one could be anything. Always start stupid... take the case off, push the ptt and see that the pin comes out enough to hit the blister button, examine the blister button and flex for trouble, etc... and just keep following the trail...
Strip it and check that the springy-thingy [RF output tab from board to antenna connector] on the board is touching the antenna plate, and not grounding against the radio chassis. It gets bent in the reassembly sometimes.
worst case is fried finals...
Second one could be anything. Always start stupid... take the case off, push the ptt and see that the pin comes out enough to hit the blister button, examine the blister button and flex for trouble, etc... and just keep following the trail...
•·•·•
Woody
---Please use the EMAIL button, not PM, tnx!---
Woody
---Please use the EMAIL button, not PM, tnx!---
-
yardbirdjr
- Posts: 424
- Joined: Thu Feb 13, 2003 10:04 am
Re: HT-1000 Help
Thanks Woody
I will give that a try
David
I will give that a try
David
-
Jim2121
- Batboard $upporter
- Posts: 881
- Joined: Wed Dec 10, 2003 2:36 pm
- What radios do you own?: A few! Most I sign out!
Re: HT-1000 Help
post your nearest city & state. Theres a member on this board who lived in the same town as me. Easy program & fix....yardbirdjr wrote:Thanks Woody
I will give that a try
David
Messages can't be intercepted if they aren't sent, can they?
Erwin Rommel
Erwin Rommel
-
yardbirdjr
- Posts: 424
- Joined: Thu Feb 13, 2003 10:04 am
Re: HT-1000 Help
Hi!
I live in Concord, North Carolina Home to Lowes Motor Speedway and the Coca Cola 600
The next biggest city is Charlotte, North Carolina
David
I live in Concord, North Carolina Home to Lowes Motor Speedway and the Coca Cola 600
The next biggest city is Charlotte, North Carolina
David
-
Jim2121
- Batboard $upporter
- Posts: 881
- Joined: Wed Dec 10, 2003 2:36 pm
- What radios do you own?: A few! Most I sign out!
Re: HT-1000 Help
David, Sending PM...
Messages can't be intercepted if they aren't sent, can they?
Erwin Rommel
Erwin Rommel
Re: HT-1000 Help
I'm going to strike a guess here. Would they be SDC9AA3DN by any chance? If so there is a resistor inside of the PA just under the shield that should be replaced with a 0 ohm. The symptoms also include really high current drain with only about 800mV of power out, looking at it through a service monitor.