I recently acquired a Standard GX4800UT UHF Trunking mobile radio, and can't seem to find any information on programming. Does anyone here have experience with this particular model?
Thank You
Standard GX4800UT Programming
Moderator: Queue Moderator
-
- Posts: 110
- Joined: Thu Jan 13, 2005 7:01 pm
Standard GX4800UT Programming
WA7IEP
WQZW304
WQZW304
Re: Standard GX4800UT Programming
They program with DOS software and they are an absolute pain in the @$$ to work with.
*IF* you can get them programmed, they are decent radios to use. I had several of them years ago, but I no longer have anything to work on them.
*IF* you can get them programmed, they are decent radios to use. I had several of them years ago, but I no longer have anything to work on them.
Jake
-
- Posts: 110
- Joined: Thu Jan 13, 2005 7:01 pm
Re: Standard GX4800UT Programming
I'm happy somebody had success with this radio. I found the correct software (4800dual.exe) and got a cable with the built-in interface electronics. No luck reading or writing to the radio. The person that sold it didn't know what the password was, or how to enter it. All I've gotten is ERROR READING PASSWORD when trying to read the radio, and cannot find "F-Table" when trying to write conventional modes to the radio. I don't know if these can be "bricked" as some Motorola radios can, but all I get now is NO DATA. The only place I could find any manuals was a European site and you'd think you were buying Gold for the prices they wanted. Quite frankly, I don't think it's worth spending the money without any hope for being able to program the radio. Do you remember any tricks to entering the password or ways to get past it, or why I get the "Error Reading F-Table" when trying to write to it? I'm beginning to realize why a trunking radio with 200 "personalities" wouldn't go for $50 on eBay.
Thank You,
Gary
Thank You,
Gary
WA7IEP
WQZW304
WQZW304