Hello,
I have a BLN6654D board in one of the card slots. I do not have a manual for this card so would it be possible to get a list of the jumpers on this card?
Thanks
Mike W8VPC
Centracom II BLN6654D JUMPERS
Moderator: Queue Moderator
- The Pager Geek
- Posts: 1250
- Joined: Fri Jun 21, 2002 10:31 pm
- What radios do you own?: Disney FRS
Re: Centracom II BLN6654D JUMPERS
Well,
Applicaion is interfacing a echolink node through a tone remote that is connected to this module.
I took another look at the board and found JU33 Squeltch enable/disable. It was enabled so i'm going to try that and see if that will make it work
thanks
mike w8vpc
Applicaion is interfacing a echolink node through a tone remote that is connected to this module.
I took another look at the board and found JU33 Squeltch enable/disable. It was enabled so i'm going to try that and see if that will make it work
thanks
mike w8vpc
Re: Centracom II BLN6654D JUMPERS
What exactly are you wanting the interface to do?
The BLN6654D Base Interface Module (BIM) is just a 600-ohm in/out interface with tone keying (or DC with a daughtercard)...
The BLN6654D Base Interface Module (BIM) is just a 600-ohm in/out interface with tone keying (or DC with a daughtercard)...
Re: Centracom II BLN6654D JUMPERS
What was happening was the audio would mute if another station's audio was weak.
JU33 was labeld Squelch and it was enabled. so i changed the jumper from enable to disable. So now if audio was weak, it will not mute.
Since there is no "radio" connected to this card, squelch is not needed.
thanks
JU33 was labeld Squelch and it was enabled. so i changed the jumper from enable to disable. So now if audio was weak, it will not mute.
Since there is no "radio" connected to this card, squelch is not needed.
thanks