Batboard

My Chief tried flashing his XTL5000 in his buggy using the current version of CPS and Firmware. He has all the correct things, legit flash key and Moto USB Cable. He started to flash it, it installed the flashzap software, started to remove the current codeplug, and now the radio will not power up whatsoever. The radio won't even display a fail code or anything. It does nothing.


Any help?

There are internal fuses, 1 on the control head and another in the brick, not a good time to change unless you have a hot air station and some type f magnification.

If you can read the radio with a USB cable(HKN6172) on the back of the brick, that should help you isolate where the problem is.

mwb9122 wrote:My Chief tried flashing his XTL5000 in his buggy using the current version of CPS and Firmware. He has all the correct things, legit flash key and Moto USB Cable. He started to flash it, it installed the flashzap software, started to remove the current codeplug, and now the radio will not power up whatsoever. The radio won't even display a fail code or anything. It does nothing.


Any help?

I hope he didn't pull the computer programming cables before it was done. There is a time during the process that looks like it is done. Just have to wait until you get a message it is complete. If not, you may be looking at a trip to the repair center.

Jim