I found a great tool to calculate WACN and System ID based on Call Signs.
I had found Eric's tool but it only went one way - WACN and System to Call.
I was looking for a simple way to put in a Call and generate the WACN and System; the spec is a bit confusing to say the least...
I finally found a single tool that converts to and from and includes a tool for SNE based setup too. It is on the right side of this page marked "P25 Calculator".
http://www.cisco.com/go/ipics
A Project 25 tool from, of all places, Cisco.
Tool to Calculate WACN & System ID or Call Sign
Moderator: Queue Moderator
-
- Posts: 152
- Joined: Wed May 02, 2012 11:30 am
Re: Tool to Calculate WACN & System ID or Call Sign
Doesn't work for me? I get this error:
"Invalid characters found in WACN ID. Only the digits 0-9 are allowed."
Andrew
"Invalid characters found in WACN ID. Only the digits 0-9 are allowed."
Andrew
- MTS2000des
- Posts: 3347
- Joined: Sat Jan 04, 2003 4:59 pm
- What radios do you own?: XTS2500, XTS5000, and MTS2000
Re: Tool to Calculate WACN & System ID or Call Sign
same here, and all the known callsigns I put in, spit out a completely different SYS ID and WACN
The views here are my own and do not represent those of anyone else or the company, the boss, his wife, his dog or distant relatives.