Batboard

I programmed this new 8400 and set up a master IP, wrote it , and now i can not read the repeater thru CPS. Any help would be greatly appreciated. TIA

I asked our Trbo experts. They suggest you may have run into an older cable where the USB driver farbles after it touches the radio. Unplug the cable from the radio and the laptop. Reinsert into a different USB port, wait for it to discover a new device, then plug into the radio, and try again.

I remember in the system planner there being an issue if the programming subnet and ip subnet were the same, then you would lose programming capability after writing the codeplug...... or something similiar.... FB