Batboard

Aquired a gold elite CRT system, 2 op positions complete w/ceb.

The GUI is telling me there's no connection between the CIE & CEB. I've tried all possible connection configurations, cables, etc. One of the CIE's is dead, so I'm working with the good one, but I don't know if it has to be addressed as op1 or not, or how to do that if it does.

Got the install manual here and in 372 pages I couldn't find any info on the topic.

I've got them both open and all switches & jumpers look the same between the 2.

Any feedback would be appreciated.

Semper Fi.

Updating...

I made a simple change to an existing CEB resource in the DB, and I can't seem to upload it, so I want to:

1.) Get rid of the OP2 COIM, and setup the remaining good CIE for OP1 use, so I'm working with the primary dispatch pos. I don't know if the reason I can't upload is because I'm working with OP2 or not. So, is there a way to "address" a CIE for specific OP pos use.

2.) Verify TDB bus assignments, because CEB cards don't match the DB. I can't seem to find any documentation that tells how to set that 8 pos dip switch for TDM bus assignment.

Ultimately I'm going to be trying to create a T88R resource....I have an idea how to do it, but I can't get past this basic stuff.

Any assistance would be welcomed.

Here you go - this should help you out.

http://batboard.batlabs.com/viewtopic.p ... 4&p=344696 Has your DIP Switch settings (Thank you D119) which have helped me out numerous times

Holy moly, didn't know that post still existed... Excellent! Yes you all are very welcome, I worked on a bunch of this way back when. Still have a 2OP CCGE CEB I occasionally use at home.

I think if you search my username in that particular forum I did a few other posts describing card model numbers, CEB setups, etc.