R2001D A3 RT1 needed

This forum exists for the purposes for discussing service monitors (This includes but is not limited to Motorola, HP, Aeroflex, GD, etc). Additional topics allowed include test procedures, interpretation of test results, where to find information about specific tests, antenna VSWR, return loss testing, duplexer and filter alignment, etc.

Moderator: Queue Moderator

Post Reply
n4xir
New User
Posts: 2
Joined: Wed Feb 08, 2017 1:52 pm
What radios do you own?: Motorolas, Kenwoods, Yaseu, GE

R2001D A3 RT1 needed

Post by n4xir »

Good day to all
I have just received a new to me R2001D service monitor. When plugged in, the oven ready and AC leds light, but nothing else. I have found a blown (exploded) RT1 thermistor on the A3 card. The manual lists the part as 06-80342B85 but I cannot locate a source of supply. Any help would be greatly appreciated.

Thank you
Bill
jry
Posts: 484
Joined: Fri Feb 06, 2004 3:14 pm

Re: R2001D A3 RT1 needed

Post by jry »

RT2 shouldbe the same value RT1. Just pull and measure ..you may have to research an equivalent to match. You should also be able to look at the markings of the good one

Sounds like you need to replace the caps and possible both thermistors.
n4xir
New User
Posts: 2
Joined: Wed Feb 08, 2017 1:52 pm
What radios do you own?: Motorolas, Kenwoods, Yaseu, GE

Re: R2001D A3 RT1 needed

Post by n4xir »

Thank you for the reply. RT2 is also damaged to the point that I don't trust the measurements. There are no markings.
jry
Posts: 484
Joined: Fri Feb 06, 2004 3:14 pm

Re: R2001D A3 RT1 needed

Post by jry »

should be 12 ohms
Post Reply

Return to “Test Equipment & RF Equipment Alignment”