Batboard

I have read old posts about this however I am not able to find much information.

Does anyone have the programming pinout for the Minitor VI pager? I know in the past it was fairly easy to rig up a programming interface for the 3, 4, and 5 pagers. I was wondering if anyone has the pinout for programming these pagers. Initially programming cradles were rather cheap however now I am unable to find one that is much short of $100.

Upon reading it seems the 6 uses the prolific USB/TTL signals so it seems to have the same connections as the other pagers did.

Also has anyone figured out the Engineering mode for the PPS?

Thanks.

Jtsou wrote:Also has anyone figured out the Engineering mode for the PPS?

To date and to the best of my knowledge, there is no Engineering Mode for the Minitor VI PPS.

"If" it even exists, it is a very closely guarded secret. I have found no evidence of it on the net.