Batboard

I have an HT1000 (UHF) in which I swapped out the back plate that holds the battery because one of the clips on the bottom was broken. The swap out was successful and the radio powers up fine and transmits like it's supposed to. The problem is when I test it's receive capability I hear the radio key up but the audio is super low to the point where you can't make out any voice. No static just a sound that tells you it's receiving the signal but no audio. I have not hooked it up to RSS yet as I'm just about finished installing it on my Panasonic Toughbook CF-27 but anyone have any ideas as to the issue? Thanks!!!

Scott S. (N4SYR)

Possibly the channel you are trying to receive is programmed for "Hear Clear" receive

Try it with a speaker mike to compare. GARY.

Hey Gary good to see you in here. I tried it with a speaker mic and I get the same unfortunately. I gotta hook it up to RSS and check the settings on it. See if there is something volume wise that needs adjusting. If not I'll take it to Chris (AJ1Q) so he can look at it.