MTR2000 & MRTI2000 Issues
Posted: Sun Feb 21, 2021 6:44 pm
I have run into a strange problem when interfacing a UHF MTR2000 to a MRTI2000 Interconnect. The system is using the standard MOT/Gai-Tronics interface cable from the MRTI connector on the MTR to the MRTI.
With the station configured as a base station everything works as it should with the MRTI. When changing the station config to repeater, (no other changes) and attempting to hang-up a previously connected call by sending a DTMF # the station will perform a reset and leave the MRTI in a hung condition requiring a power-cycle to reset.
Have tried this same setup using 2 different MTR's and 2 different MRTI's with the same result, so I can't rule out one or the other as the problem.
Anyone have any ideas on this issue?
Thanks,
Don
With the station configured as a base station everything works as it should with the MRTI. When changing the station config to repeater, (no other changes) and attempting to hang-up a previously connected call by sending a DTMF # the station will perform a reset and leave the MRTI in a hung condition requiring a power-cycle to reset.
Have tried this same setup using 2 different MTR's and 2 different MRTI's with the same result, so I can't rule out one or the other as the problem.
Anyone have any ideas on this issue?
Thanks,
Don