Page 1 of 1

Maxtrac receiver 900Mhz. Question using 896-902 to receive

Posted: Mon Jul 12, 2004 5:07 pm
by Frisky
Hi
Will a 900 Mhz Maxtrac receiver from 896 thru 902 Mhz?
No transmit needed.
If so how do I do It.
Thank you in advance.
Don

Posted: Mon Jul 12, 2004 5:17 pm
by kg4lmt
Typically that portion is used for transmit, that's not to say it can't be done. But, the receive sensitivity would probably in the neighborhood of
1 volt. You would do better converting a conventional D25 or D35 800MHz Maxtrac for a receiver. If you run a search in this forum you will see several posts on how to do it.

Charles

Posted: Mon Jul 12, 2004 5:22 pm
by Frisky
Hi
I'm looking to use as a receiverin the 896-902 band.
I would like to have a lot less that 1v rf sensititve.
Hopeing for atleast .5 or better sensitivity.
Don

Posted: Mon Jul 12, 2004 7:23 pm
by Max-trac
Use an 800 radio. It will rx there fine. Just pull and jumper the Murata filters.
You have to clip a lead on one transistor too, if I remember correctly.
Try using the search link above, there was discussion a while ago.