Page 1 of 1
Minitor 5 Group Call
Posted: Tue Jan 13, 2009 10:40 am
by explorerny
I am trying to program my pager to go off for Group Call, Long tone B. But right now it is going off for everything. I am using R138, Tone A and Tone B is duty and then long tone B is all call when off duty. Any ideas ?
Re: Minitor 5 Group Call
Posted: Tue Jan 13, 2009 7:18 pm
by MOTO_LR
Go to the FUNCTION SWITCHES Tab and place a check in the ENABLE ON/OFF DUTY BOX for the Mode Switch position or positions where you want your pager to respond to the Long Tone B only.
Now go to the CHANNEL F1 Tab and to the right of the Tone1 & Tone 2, set the Duty to OFF.
Make sure that the Duty is set to ON for Group Call 1 (your Long Tone B).
Now when you go to the Mode Switch position(s) where the ON/OFF Duty function is enabled (Box checked)... the decoder will see that the Tone 1/Tone 2 set is turned OFF and the pager will activate only with the Long Tone B.
When you are on a Mode Switch position where the ON/OFF Duty Box is not checked, the decoder will activate for all tone sequences in the list.
Hope this helps!
Bob, CLARKCOMM