Batboard

I have a lot of time put into programming our ht1250's (dozens and dozens of MDC Call list entries).

I know you cannot program the ht1550 using the ht1250 file, but how can I cut and paste or easily program the ht1550 without having to re-enter all that data into a new file?

Any help would be appreciated.

Thanks

You can't...sorry. I've been in your boat...one customer with 5 different HT/CDM codeplug templates for all their different models. Very complicated programming too.

Todd

open both codeplugs and drag & drop from one to the other. but it might not transfer all the info, the 1550 sometimes has more boxes to fill so you will still have to go thru them even after you move them.

HLA wrote:open both codeplugs and drag & drop from one to the other. but it might not transfer all the info, the 1550 sometimes has more boxes to fill so you will still have to go thru them even after you move them.

Have you ever programmed these models? Drag & drop is NOT a feature of the HT/CDM CPS...only for the Astro/25 & MTS/MCS CPS.

Todd

you're right, i was reading ht and thinking mts

so if you have the same model radio for example an motorola ex600 can i open my cp and then write it to anothe radio and it will work?

it should as long as the model number matches. the worst that will happen if it can't is it will tell you why i couldn't do it. you won't hurt the radio.

oh thank you soooo much! so basicly any same radio with the same model number will work in cloning thats awesome ive been searching the board formonths for that info!

I programmed my 25w cdm1250 info into my 50w cdm1250. Different model #'s