Page 1 of 1

HT1000 D model issue with 2.5 steps

Posted: Wed Dec 29, 2010 8:50 am
by firetech792
Ok I'm confused. Programming this for some one.
Have an HT1000 "D" model but it won't take the following freqs:
155.9175 and 156.0375
It rounds them off to a nearest freq.
Any one have any clues? Maybe older firmware? I never ran into this before. Although these are new frequencies to me.
Thanks
Pete

Re: HT1000 D model issue with 2.5 steps

Posted: Wed Dec 29, 2010 3:23 pm
by MTS2000des
I just checked using HT1000 RSS V3.03 and two codeplugs of early 1998 vintage DN HT1000's (both have V4.0 F/W) and no problem entering either frequency. What version of HT1000 RSS are you using?

Re: HT1000 D model issue with 2.5 steps

Posted: Thu Dec 30, 2010 4:16 am
by firetech792
My RSS version is a 2.00
Radio is 4.02
Guess my RSS might be the issue. Thanks.

Re: HT1000 D model issue with 2.5 steps

Posted: Thu Dec 30, 2010 4:57 am
by MTS2000des
yep, you'll need 3.03 or later to program a DN. I am surprised it doesn't complain and give you the "invalid model, serial number" error and refuse to unpack the codeplug.

Re: HT1000 D model issue with 2.5 steps

Posted: Thu Dec 30, 2010 11:23 am
by firetech792
I do get those warnings some times but I always hit F9, save workspace any way (or something like that)
Thanks again